Vax Turbo Force V-060P Spécifications télécharger pdf (Page 30)

5. Count the number of gaskets.

6. Clean the rotor, rotor slots and housing and inspect

for wear or damage.

If the housing needs to be bored or honed, remove

only as much material as is necessary to give a

smooth clean bore.

The maximum over bore we recommend is .060 inch.

(A new housing has a bore of 6.300 inches.)

If you bore or hone the housing, remove the four way

valve assembly and internal check valve ball prior to

machining.

7. Inspect vanes, bearings and seals

and replace as necessary.

A new vane is flush with the outside

diameter of the rotor.

If they are worn more than 1/4" they

should be replaced.

We recommend replacing vanes in sets.

If the ends of the vanes are chipped or delaminated

they should be replaced.

The seals should be soft and pliable.

The bearing should turn smoothly.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 46 47

Pas de commentaire

Vax Turbo Force V-060P Spécifications Page 30