Vax VX1 Guide de l'utilisateur télécharger pdf (Page 9)

Vax Careline: AU: 1300 361 505

NZ: 0800 800 900

vax.com.au

vax.co.nz 8

Operation

Installing side brushes for use in sweeping mode

To install

Push the brush directly onto the holder until

it snaps into position.

To remove or replace

Hold the brush and pull upward to remove the brush

as shown.

Adjustment of cli sensors

If the distance between the stair and the ground is short, please adjust both windows of “cli ” sensors (A)

to “2” or “1” or “0” position to prevent the cleaner from falling down stairs. Please test it before working.

ATTENTION: If the colour of the  oor is dark (e.g. Black), and robot goes backwards continuously, close the

window position to the “1” to increase the cli sensor’s sensitivity (C) position.

BOTTOM

1 2 30

Cli sensors prevent the robotic sweeper from falling o stairs and ledges. There are 3 sensors located on the

underside of the robotic sweeper.

WARNING: to reduce the risk of injury from moving parts – turn power o (0=o ) and unplug charger

before adjusting.

WARNING: to reduce the risk of injury from moving parts – turn power o (0=o ) and unplug charger

before installation and removal/replacement.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Vax VX1 Guide de l'utilisateur Page 9