Vax 4000 Model 200 Manuel de service télécharger pdf (Page 30)

Figure 12: Mounting the Cable Concentrator

To Wall

MLO-000651

NOTE: Be sure you mount the cable concentrator less than 7.6 meters (25

feet) from the system, to ensure the BC16D cable reaches the system.

7.2 Connecting Parallel Printers to the System

You can connect up to two parallel printers for each LPV11 module installed

in your system.

To connect parallel printers to the LPV11 module:

1. Find a BC27L–30 cable.

2. Feed one end of that cable under the system from the back or side.

Then insert it into the connector labeled J1 on the module cover. Lock

the connector in place by using the bail latches.

3. Insert the other end of the cable into the printer.

Follow the same procedure for connecting a second printer to the LPV11

module, except insert the cable into the connector labeled J2 on the module

cover.

7.3 Connecting Synchronous Modems to the System

You can connect up to two synchronous modems for each DSV11 module

installed in your system.

To connect a synchronous modem to a DSV11 module, using a protocol

adapter and extension cable:

VAX 4000 Model 200 (BA430) Installation 21

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 97 98

Pas de commentaire

Vax 4000 Model 200 Manuel de service Page 30